2026/04/29    [공지] FSP 제품 서비스 업무 종료 안내
2026/04/24    2026년 5월 연휴 휴무 안내


제품 스펙 : FSP700-62R01 New Page 2
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+5Vsb 0.0A 2.0A ±5% 100mV P-P
-12V 0.0A 0.8A ±10% 200mV P-P
-5V 0.0A 0.3A ±10% 200mV P-P
+12V 0.2A 15.0A ±5% 200mV P-P
+5V 0.5A 33.0A ±5% 100mV P-P
+3.3V 0.5A 28.0A ±4% 80mV P-P

Safety
Features
　
  • High efficiency
  • Low Ripple & Noise
  • Output over voltage protection
  • Short circuit protection on all outputs
  • Resetable power shut down
  • 100% burn-in under high ambient temperature(50℃)
  • Vacuum-impregnated transformer
  • MTBF:100K hours at 25℃
  • 100% Hi-pot tested
  • line input fuse protection
    		•
    Specifications
    　
    INPUT SPECIFICATIONS  　
           ˙Input voltage:  Full Range Input
           ˙Input frequency: 60 Hz / 115V;
    50 Hz / 230V.
           ˙Inrush current: 60Amps-peak/100Vrms
           ˙Input current: 7.0Amps/115Vac
    3.5Amps/230Vac

    　

    OUTPUT SPECIFICATIONS 　
           ˙Over voltage protection: +12V ouptut: 15.6V max;
    +5V output: 6.5V max;
    +3.3V output: 4.5V max. 
           ˙Overload protection: One module:
    +5V:    45Amps;
    +3.3V: 40Amps; 
    +12V : 25Amps;
    +5Vsb:5Amps;

    Two module:
    +5V:    48Amps;
    +3.3V: 42Amps; 
    +12V : 25Amps;
    +5Vsb:10Amps;
           ˙Short circuit protection: The short circuit on any DC output shall not cause any damage to the power supply, including the primary fuse.

    　

    GENERAL SPECIFICATIONS 
           ˙Hold-up time: 16ms
           ˙Efficiency: 65% min. 110Vac at full load
           ˙MTBF: 100,000 hours at full load at 25℃
           ˙Power good signal: 100ms to 500 ms
    　


    ENVIRONMENTAL SPECIFICATIONS
          ˙Operating temperature: One  module 5℃ to +40℃
    Two module 0℃ to +50℃
          ˙Storage temperature: -20℃ to +60℃
          ˙Relative humidity: Operating: 20% to 90% non-condensing
    Storage: 5% to 95% non-condensing
    OutPut
    　 　
    Output Voltage Min. load Max. load Load Reg. Ripple & Noise
    +5Vsb 0.0A 2.0A ±5% 100mV P-P
    -12V 0.0A 0.8A ±10% 200mV P-P
    -5V 0.0A 0.3A ±10% 200mV P-P
    +12V 0.2A 15.0A ±5% 200mV P-P
    +5V 0.5A 33.0A ±5% 100mV P-P
    +3.3V 0.5A 28.0A ±4% 80mV P-P
    　
    ‧+3.3V & +5V total output shall not exceed 220 W.
    ‧+3.3 V & +12V total output shall not exceed 250W.