2026/04/29    [°øÁö] FSP Á¦Ç° ¼­ºñ½º ¾÷¹« Á¾·á ¾È³»
2026/04/24    2026³â 5¿ù ¿¬ÈÞ ÈÞ¹« ¾È³»


Á¦Ç° ½ºÆå : FSP650-802U New Page 2
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+3.3V 0.5A 30.0A +-5% 50mV P-P
+5V 0.5A 30.0A +-5% 50mV P-P
+12V1 0.3A 12.5A +-5% 120mV P-P
+12V2 0.3A 12.5A +-5% 120mV P-P
+12V3 0.5A 14.0A +-5% 120mV P-P
+12V4 0.3A 8.0A +-5% 120mV P-P
-12V 0.0A 0.8A +9%-5% 120mV P-P
+5Vsb 0.0A 2.0A +-5% 50mV P-P
-5V 0.0A 0.3A +-10% 120mV P-P

Safety
Features
¡¡
  • Support Intel Nocona CPU
  • High efficiency
  • Low Ripple & Noise
  • Output over voltage protection
  • Short circuit protection on all outputs
  • Resetable power shut down
  • 100% burn-in under high ambient temperature(50¡É)
  • Vacuum-impregnated transformer
  • MTBF:100K hours at 25¡É
  • 100% Hi-pot tested
  • line input fuse protection
Specifications
¡¡ ¡¡
¡¡ ¡¡
INPUT SPECIFICATIONS  ¡¡
       ¢«Input voltage:  Full Range Input
       ¢«Input frequency: 47 Hz to 63 Hz
       ¢«Inrush current: 50Amps-peak/115Vac
50Amps-peak/230Vac
       ¢«Input current: 8.0Amps/115Vac
4.0Amps/230Vac

¡¡

OUTPUT SPECIFICATIONS ¡¡
       ¢«Over voltage protection: +12V output: 13.3V - 15.6V;
+5V output:   5.7V - 6.5V;
+3.3V output:3.7V - 4.5V.
       ¢«Overload protection: +5V:    45Amps;
+3.3V: 45Amps; 
+12V1:17Amps-20Amps;
+12V2:17Amps-20Amps;
+12V3:17Amps-20Amps;
+12V4:17Amps-20Amps.
       ¢«Short circuit protection: The short circuit on any DC output shall not cause any damage to the power supply, including the primary fuse.

¡¡

GENERAL SPECIFICATIONS 
       ¢«Hold-up time: 20ms at 115Vac/60Hz,
20ms at 230Vac/50Hz.
       ¢«Efficiency: 70% min. 115Vac at full load
       ¢«MTBF: 100,000 hours at full load at 25¡É
       ¢«Power good signal: 200ms to 1000 ms
¡¡


ENVIRONMENTAL SPECIFICATIONS
      ¢«Operating temperature: 0¡É to +50¡É
      ¢«Storage temperature: -40¡É to +70¡É
      ¢«Relative humidity: 5% to 95% RH non-condensing
¡¡

OutPut
¡¡ ¡¡
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+3.3V 0.5A 30.0A +-5% 50mV P-P
+5V 0.5A 30.0A +-5% 50mV P-P
+12V1 0.3A 12.5A +-5% 120mV P-P
+12V2 0.3A 12.5A +-5% 120mV P-P
+12V3 0.5A 14.0A +-5% 120mV P-P
+12V4 0.3A 8.0A +-5% 120mV P-P
-12V 0.0A 0.8A +9%-5% 120mV P-P
+5Vsb 0.0A 2.0A +-5% 50mV P-P
-5V 0.0A 0.3A +-10% 120mV P-P

‧+3.3V & +5V total output shall not exceed 220 W.
‧+3.3 V &+5V & +12V total output shall not exceed 630W.
‧-5V Optional