|
 |
Safety |
|
|
|
|
|
|
Features |
|
| |
• High efficiency
• Low ripple & noise
• Output over voltage protection
• Short circuit protection on all outputs
• Resettable power shut down
• Approved by UL, CSA, TUV, NEMKO, CB & CE
• Internal 8 cm fan
• Under 40dBA noise design at full load
• 100% burn-in under high ambient temperature (50°C)
• Vacuum-impregnated transformer
• MTBF: 100K hours at 25°C
• 100% Hi-pot tested
• Line input fuse protection
• Active PFC (Power Factor Correction) circuit
• Complies with EN61000-3-2
• AC input full range |
|
|
|
Specifications |
|
| |
|
Input Specifications |
• Voltage:
|
100-240 VAC full range |
| • Frequency: |
47 Hz to 63 Hz |
| • Inrush current: |
60A cold 90A warm at 132 VAC |
| • Input current: |
6 amps maximum / 115 Vrms, 60 Hz.
4 amps maximum / 230 Vrms, 50Hz
|
| |
|
Output Specifications |
| • Over-voltage
protection: |
+5V, +3.3V, +12V1, +12V2 |
| • Over-current protection: |
+5V, +3.3V, +12V1, +12V2 |
| • Overload protection: |
150% max. |
| • Remote ON/OFF control:
|
The power supply shall accept a logic collector
level which
will disable / enable all output voltage (excluding +5V
standby). |
| • Power good signal: |
turn-on delay 100 ms to 500 ms |
| |
|
General Specifications |
| • Efficiency: |
75% min., at full load |
| • Hold-up time: |
17ms minimum at full load & nominal input voltage |
| |
|
Environmental Specifications |
• Temperature range:
|
operating 0°C~50°C, storage -20°C~+80°C |
| • Humidity: |
5~95% RH |
| • Dielectric withstand: |
input / output 1800 VAC for 1 second,
input to frame ground 1800VAC for 1 second |
|
|
|
|
OutPut |
|
|
| |
|
Output Voltage |
Min. load |
Max. load |
Load Reg. |
Ripple & Noise |
| +3.3V |
0.5A |
30.0A |
±5% |
50 mV P-P
|
| +5V |
0.3A |
30.0A |
±5% |
50 mV P-P
|
| +12V1 |
1.0A |
14.0A |
±5% |
120 mV P-P
|
| +12V2 |
1.0A |
15.0A |
±5% |
120 mV P-P
|
| -12V |
0.0A |
0.5A |
±10% |
120 mV P-P
|
| +5Vsb |
0.0A |
2.0A |
±5% |
50 mV P-P
|
|
| |
| |
• +3.3V&+5V
total output shall not exceed 152 Watts.
• +3.3V&+5V&12V1&+12V2 total output shall not exceed 380
Watts. |
|
|
|
|
|
