2026/04/29    [°øÁö] FSP Á¦Ç° ¼­ºñ½º ¾÷¹« Á¾·á ¾È³»
2026/04/24    2026³â 5¿ù ¿¬ÈÞ ÈÞ¹« ¾È³»







FSP500-80BU
New Page 2
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+5Vsb 0.0A 2.0A ¡¾5% 50mV P-P
-12V 0.0A 0.8A ¡¾10% 120mV P-P
+12V3 0.2A 18.0A ¡¾5% 120mV P-P
+12V2 0.2A 15.0A ¡¾5% 120mV P-P
+12V1 0.2A 15.0A ¡¾5% 120mV P-P
-5V 0.0A 0.3A ¡¾10% 120mV P-P
+5V 0.2A 30.0A ¡¾5% 50mV P-P
+3.3V 0.2A 30.0A ¡¾5% 50mV P-P

¡¤ Å©±â : 250 x 100 x 40.5 mm
¡¤ Àû¿ë±â±â : For Server & Workstation
¡¤ Watt : 500
¡¤ PFC : Active PFC
¡¤ Äð¸µÆÒ : 40mm
¡¤ Drawing :
Drawing

 FSP500-80BU Ãâ½ÃÀÏ : 2007-05-25 15:33:27

Safety
Features
¡¡
  • Support Intel Nocona CPU
  • High efficiency
  • Low Ripple & Noise
  • Output over voltage protection
  • Short circuit protection on all outputs
  • Resetable power shut down
  • 100% burn-in under high ambient temperature(50¡É)
  • Vacuum-impregnated transformer
  • MTBF:100K hours at 25¡É
  • 100% Hi-pot tested
  • line input fuse protection
Specifications
¡¡ ¡¡
¡¡ ¡¡
INPUT SPECIFICATIONS  ¡¡
       ¢«Input voltage:  Full Range Input
       ¢«Input frequency: 47 Hz to 63 Hz
       ¢«Inrush current: 80Amps-peak/115Vac
120Amps-peak/230Vac
       ¢«Input current: 9.0Amps/115Vac
5.0Amps/230Vac
¡¡

OUTPUT SPECIFICATIONS ¡¡
       ¢«Over voltage protection: +12V3 output:15.6V max;
+12V2 output:15.6V max;
+12V1 output:15.6V max;
+5V output: 6.5V max;
+3.3V output: 4.5V max. 
       ¢«Overload protection: +5V:    45Amps;
+3.3V: 50Amps; 
+12V1:19.5Amps;
+12V2:19.5Amps;
+12V3:19.5Amps.
       ¢«Short circuit protection: The short circuit on any DC output shall not cause any damage to the power supply, including the primary fuse.
¡¡
GENERAL SPECIFICATIONS 
       ¢«Hold-up time: 18ms at 115Vac/60Hz,
18ms at 230Vac/50Hz.
       ¢«Efficiency: 70% min. 115Vac at full load
       ¢«MTBF: 100,000 hours at full load at 25¡É
       ¢«Power good signal: 100ms to 500 ms
¡¡


ENVIRONMENTAL SPECIFICATIONS
      ¢«Operating temperature: 0¡É to +50¡É
      ¢«Storage temperature: -20¡É to +80¡É
      ¢«Relative humidity: 5% to 95% RH non-condensing
¡¡

OutPut
¡¡
Output Voltage Min. load Max. load Load Reg. Ripple & Noise
+5Vsb 0.0A 2.0A ¡¾5% 50mV P-P
-12V 0.0A 0.8A ¡¾10% 120mV P-P
+12V3 0.2A 18.0A ¡¾5% 120mV P-P
+12V2 0.2A 15.0A ¡¾5% 120mV P-P
+12V1 0.2A 15.0A ¡¾5% 120mV P-P
-5V 0.0A 0.3A ¡¾10% 120mV P-P
+5V 0.2A 30.0A ¡¾5% 50mV P-P
+3.3V 0.2A 30.0A ¡¾5% 50mV P-P

‧+3.3V & +5V total output shall not exceed 220 W.
‧-5V &-12V total output shall not exceed 10 W.
‧+12V1 &+12V2 & 12V3 total output shall not exceed 40A.
‧+3.3 V &+5V & +12V total output shall not exceed 480W.